| DodgeRam.info > TSB's > 09-004-06 |
TSB 09-004-06
Accessory Drive Belt Chirp At Shut Down
| Visit Geno's Garage for Truck accessories. |
 |
| DodgeRam.info > TSB's > 09-004-06 |
| Visit Geno's Garage for Truck accessories. |
|
Date: March 31, 2006
Models: 2003 -2006 (DH/D1) Ram Truck (Diesel)
NOTE: This bulletin applies to vehicles equipped with a Diesel Engine, sale code ETH.
Overview:
This bulletin involves installing an overrunning clutch pulley on the generator.
Symptom/Condition:
A chirping sound maybe heard coming from the accessory drive belt when the engine
is
shut down.
Diagnosis:
If a customer indicates that the condition is present, perform the
Repair Procedure.
Parts Required:
| Qty. | Part No. | Description |
| 1 | 05183490AA | Overrunning Clutch Pulley |
Special Tools/Equipment Required:
| 8823 | Generator Shaft Holder |
Repair Procedure:
| 1. | Disconnect and isolate both negative battery cables. |
| 2. | Remove the air cleaner box. |
| 3. | Loosen the accessory drive belt and disengage it from the generator. |
| 4. | Remove the generator. |
| 5. | Remove the drive pulley from the generator. |
| 6. | Install the new drive pulley, p/n 05183490AA, using toll number 8823 to
hold the generator shaft. Tighten the nut to 80 Nm (60 ft. lbs.) |
| 7. | Install the generator. Tighten the bolts to 41 Nm (30 ft. lbs.) |
| 8. | Install the accessory drive belt. |
| 9. | Install the air cleaner box. |
| 10. | Connect the negative battery cables. |
Policy: Reimbursable within the provisions of the warranty.
Time Allowance:
| Labor Operation No: | Description | Amount |
| 08-05-01-98 | Install Overrunning Clutch Pulley | 0.5 Hrs. |
Failure Code:
| ZZ | Service Action |
I would like to thank Bob Bergevin, Arthur Cantrall, Barry Drodge, David Lovell, Bill Maurits, and Steve for supplying the information for these bulletins. And a big thank you goes to Geno's Garage for making DodgeRam.info possible. |
This page was edited on: May 3, 2004